STAINLESS DOG ENTERPRISES

STAINLESS STEEL ROLL BARS FOR BMW Z3 96-02

INSTALLATION

Z3's built after Jan 97 have Torx bolt/holding lugs welded on each frame riser. 96 and 97 Z3's built before Jan 97 should have hold down lugs welded on. These are supplied with the bar. In both cases 98 and newer upper trim planes (roll bar insert panels) must be used because they include an access window for tightening the hold down bolts.

Trim Panes can be purchased at your local BMW dealer for $35 and the cover pane for $6. They are cheaper by the way of the Internet.

"New" Alternate method of installation on Z3's built "after 97" (Click Here for photos and instructions)

click photo to enlarge

NEWER TRIM PANE

Beige Interior Part NO#
Upper trim pane: 51438407167 51438407168
Trim pane cover: 51438407173 51438407172

Black Interior Part NO#
Upper trim pane: 51438407165 51438407166
Trim pane cover: 51438407171 51438407172

	INSTALLING TRIM PANES: refer to photos above and left

1.	1. Remove the 4 screws that hold the storage compartment lid on. Remove lid.

2.	2.Remove the 10 screws in the storage compartment insert. Location:2 front screws, 6 rear screws, and 2 inside. Remove storage tray liner.

3.	3. Remove storage compartment housing by unscrewing the 3 screws in the back and the 2 screws inside the compartment.

4.	4.Remove the upper trim pane by taking out 3 screws. Remove the seat belt from the seat and slip pane off.

5.	5. Slip pane on and mark hold down lugs so bolts are accessible thru window. Remove pane.

6.	6.Drill 2-3/8" holes and weld lug on. This is an easy task that can be done by a welder or a good body shop.

Created By: bud smith Last Updated:6/21/08 by Bud Smith